I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?
1 point
*
Heat soak should not change what you have here. During the heat soak, machine expands a little. You will get a more usefull Z / mesh when the machine gets to equilibrium.
If you still have problems after that, it’s probably a X twisted, see the linked document above. Unfortunately I do not have much time to dig into your configs.
I don’t have any experience with beacon. I use Tap or Klicky. With a twisted X, as tap use the nozzle, it should work even with a twisted X
