You are viewing a single thread.
View all comments
35 points

“I can tell you, Mr. Speaker, that many times I have opened the dishwasher, loaded properly, with the right amount of dishwashing liquid or pod put in, that all the dishes aren’t clean,” the orator declared.

Hmm.

Not really the point of the article, but that’s not really using the dishwasher in the intended fashion. Those normally use powder. Normally, liquid detergent is for hand dishwashing and pods don’t do an ideal job because they don’t dissolve and release their detergent until after the rinse cycle, whereas normally dishwashers do have a spot for putting powder used during the rinse cycle.

Technology Connections did a video on this a while back.

https://www.youtube.com/watch?v=_rBO8neWw04

permalink
report
reply
32 points
*

They make liquid detergent (It’s a gel) for dishwashers. Perhaps that’s what he was talking about.

I’m not defending the guy, I’m just saying that I’ve been using the stuff for a couple of decades. It’s made by Cascade.

permalink
report
parent
reply
8 points

What people forget is their own water hardness. It determines how much detergent you should actually use.

permalink
report
parent
reply
2 points

A small dish of white vinegar in the bottom is s great rinse agent.

permalink
report
parent
reply
4 points

I believe TC made a video calling out the inadequacy of liquid dishwasher detergent, and having made the switch to powder I have to say that I agree. I used to get discoloration building up on coffee mugs with the liquid stuff, this went away right away when switching to powder.

permalink
report
parent
reply
13 points

After that video, I did try switching from pods to powder, and for my dishwasher it sucked. The powder didn’t fully dissolve, and would end up settling all over everything, requiring me to hand wash or wash them again.

permalink
report
parent
reply
5 points

That’s too much powder, which can happen if your water’s not hard and you fill the space up.

permalink
report
parent
reply
2 points

I tried varying amounts, no matter how little I put in it always happened. I think it’s probably an issue with our dishwasher, it’s an old, crappy apartment model and probably doesn’t work 100% correctly.

permalink
report
parent
reply
6 points

He uses liquid detergent in his extensive example and regularly has the bottle feature alongside a box of powder.

The big difference between liquid and powder is powder allows for two different cleaning agents whereas if they both are in a liquid, they react with each other. He doesn’t bring this up in the video, but I think he mentions it in another one.

permalink
report
parent
reply
6 points

Also if you’re having to wash multiple times, there’s a good chance your mistake it’s not running the water until hot at the tap before running the dishwasher. First cycle is a just hot water rinse which actually does a pretty decent percentage of the debris removal. But that step works best with hot water when there is any grease or caked on food. The first cycle just uses a bit of water from the hot water line connected to it, no heater. So if your hot water line is still cold at the tap, it’s cold in the dishwasher too.

permalink
report
parent
reply
1 point

Dishwashers already have heating coils and temperature sensors. It’s 2024, why don’t they handle that on their own?

permalink
report
parent
reply
1 point
*

If you run it correctly, with the hot water at the tao, the first cycle is only a few minutes long and the box is insulated, so there is very little heat loss. It drains all that water out after a few minutes so that all that grease and debris isn’t being sprayed all over your dishes that it is trying to wash. There is no reason to add more heat to that cycle, and the heat added would be minimal since the cycle doesn’t last long. The next cycle, the detergent cycle is much longer, so the water will lose heat over the duration of the cycle if not heated. That is what the heating coil is used for, to maintain the heat of the, ideally, already hot water.

Why not use the heating element one the first cycle? Energy efficiency, runtime, and equipment cost/complexity. It is a waste of energy to heat cold water when you should already have a tank full of heated water somewhere in your house with a line connected to the dishwasher. But not only that, heating water takes a considerable amount of time. To heat a gallon of water by 80 degrees Fahrenheit (average cold tap is 60 degrees, vs 140 in water heater) with a typical heating element in a dishwasher, it would take just under 15 minutes of continuous heating to get it to temp, and you would need to do that before you started cleaning if you want it to matter. And every cycle after that will need to heat the water from cold too. With 4 cycles to a normal wash (if I’m not mistaken), that’s an extra hour to every load of dishes. Then on top of that, you need a thermostat that’s currently unnecessary, to let the dishwasher know when it’s reached temp. The temperature sensor that is currently in your dishwasher is dedicated overheat sensor to make sure the system doesn’t get too hot and become a safety hazard. It’s a simple kill switch, too simple to serve both purposes. So you would need both sensors, not just the one, or a more complicated and expensive sensor.

It’s not like they couldn’t just use the heating element on the initial rinse. They could. But there’s no good reason to add extra time, sensors and power usage on an appliance when you already have an appliance that’s already done all of that for you. You just have to clear the line of the unheated water. It will save to time and money.

permalink
report
parent
reply
5 points
*

Doubt liquid dishwasher detergent is the problem. He’s probably not pre-rinsing before loading them in.

Had a dumbass roommate that had steak and fries every dinner, and would leave the grease and a massive pool of ketchup on the plate every time, then run the dishwasher days later after everything was dry. All it did was bake it onto the plates and require some heavy scrubbing to get off.

permalink
report
parent
reply
5 points

Properly used dishwashers do not require pre-rinsing. It’s a waste to do so.

permalink
report
parent
reply
3 points

Some people take that to mean that you don’t have to clear the food residue off the plate I have found.

permalink
report
parent
reply
1 point

I have never found a dishwasher that requires less pre-wash than me just washing the whole dish by hand anyway. Like, if I already have to take it to the sink and start getting food off, I might as well just finish the job right there.

permalink
report
parent
reply
1 point

You’re not supposed to pre-rinse dishes. It messes up the sensors by suggesting the dishes are already clean, and detergents are designed to bind to the particles on your dishes, making them work less well.

https://www.goodhousekeeping.com/home/cleaning/a33322/stop-prerinsing-dishes/

permalink
report
parent
reply
5 points

Pods seem to do a fine job in our dishwasher.

permalink
report
parent
reply
5 points

Pods leave the first cycle without any detergent. Having powder allows you to provide detergent for both cycles - as intended - your dishwasher will work even better.

permalink
report
parent
reply

News

!news@lemmy.world

Create post

Welcome to the News community!

Rules:

1. Be civil

Attack the argument, not the person. No racism/sexism/bigotry. Good faith argumentation only. This includes accusing another user of being a bot or paid actor. Trolling is uncivil and is grounds for removal and/or a community ban. Do not respond to rule-breaking content; report it and move on.


2. All posts should contain a source (url) that is as reliable and unbiased as possible and must only contain one link.

Obvious right or left wing sources will be removed at the mods discretion. We have an actively updated blocklist, which you can see here: https://lemmy.world/post/2246130 if you feel like any website is missing, contact the mods. Supporting links can be added in comments or posted seperately but not to the post body.


3. No bots, spam or self-promotion.

Only approved bots, which follow the guidelines for bots set by the instance, are allowed.


4. Post titles should be the same as the article used as source.

Posts which titles don’t match the source won’t be removed, but the autoMod will notify you, and if your title misrepresents the original article, the post will be deleted. If the site changed their headline, the bot might still contact you, just ignore it, we won’t delete your post.


5. Only recent news is allowed.

Posts must be news from the most recent 30 days.


6. All posts must be news articles.

No opinion pieces, Listicles, editorials or celebrity gossip is allowed. All posts will be judged on a case-by-case basis.


7. No duplicate posts.

If a source you used was already posted by someone else, the autoMod will leave a message. Please remove your post if the autoMod is correct. If the post that matches your post is very old, we refer you to rule 5.


8. Misinformation is prohibited.

Misinformation / propaganda is strictly prohibited. Any comment or post containing or linking to misinformation will be removed. If you feel that your post has been removed in error, credible sources must be provided.


9. No link shorteners.

The auto mod will contact you if a link shortener is detected, please delete your post if they are right.


10. Don't copy entire article in your post body

For copyright reasons, you are not allowed to copy an entire article into your post body. This is an instance wide rule, that is strictly enforced in this community.

Community stats

  • 14K

    Monthly active users

  • 10K

    Posts

  • 197K

    Comments