spckls

According to JerryRigEverything, they actually run you through a mac mini on their server farm. He said he has info about that confirmed by the devs. Not sure what’s true, but i usually trust him, seems like a good guy.

It took some time to find the culprit.

It’s under:

Filament settings -> Cooling -> Cooling thresholds -> Slow down if layer print time is below: # - and - Min print speed: #

I am running a bit hot, yes, 215, and the extruder is bowden feed. It does tend to ooze a bit like all bowdens do, that’s why i have to get my speeds and accelerations on point, because the “dynamic” speed/extrusion settings never provide good results for this printer and i don’t know how to account for the oozing on speed changes.

I’d love to upgrade to a direct extruder, i’m currently using e3d v6 hot end. Do you have any suggestions?

Damn, i would’ve never thought about that. Went to check the speed in prusa, would you look at that…

Perfectly corresponds to the bulges.

Thank you, Detective Carighan!