cross-posted from: https://mander.xyz/post/16531580

I have tried to follow several tutorial to setup using either ip or nmtui:

• https://linuxconfig.org/how-to-use-bridged-networking-with-libvirt-and-kvm
• https://www.redhat.com/sysadmin/setup-network-bridge-VM

However, the bridge inherits the MAC address of host after enslaving the host hardware enp1s0.... This causes my router to give both the host and the bridge the same ip address, making the ha instance inaccessible.

The red hat tutorial clearly show that the bridge and the host have different IP, so I was wondering if I am doing something wrong.

---

Alternatively, I can set the home assistant vm to run in NAT and port forward from host, but I have several devices that communicate over different ports. So it would be annoying to forward all these ports. Not to mention, many appliances don’t have documentation about the ports they use.

I can also potentially use virtualbox, but it is not well supported on silverblue, especially with secureboot enabled.