The company says in the documents that the front windshield wiper motor controller can stop working because it’s getting too much electrical current. A wiper that fails can cut visibility, increasing the risk of a crash. The Austin, Texas, company says it knows of no crashes or injuries caused by the problem.
In the other recall, a trim piece along the truck bed can come loose and fly off, creating a hazard for other motorists.
Tesla says in documents that the trim piece is installed with adhesive, and that may not have been done properly at the factory.
I mean most of the issues have been from the assembly process and not the fundamental design. However I would argue designing something you can’t reliably assemble is just as bad. Adhesive needs to be done right on every unit and it’s impossible to visually inspect it in this application. Clips are a pain in the ass but I’ll take them over glued on trim any day of the week.
