Got an anycubic resin printer and I’m using their high speed resin (because it was bundled for free), and i tried to send a file using the high speed setting.
After the print it was seemed to be ok, then after i left in a bath of ethanol (IPA can’t be found in stores in my country) i got all those holes.
What’s the problem?
A slicer problem? The ethanol bath? The high speed resin that’s not good?
It’s not air bubbles, they wouldn’t cause such huge holes.
I’m guessing that your 3d moddel bad. Intersection edges, wrong normals, that kind of stuff.
Try this: https://all3dp.com/2/stl-repair-fixer-tool-online-offline/
To clarify: the issue is that the bad 3d moddel leaves you with very thin walls which get destroyed during the wash
the slicer said the model needed a repair (which it did), but then it also does this with other stuff. Later I try with a profile with more exposure time
I see, but that just makes me want to blame the model even more.
What can happen if you repair a bad model is that intersecting faces are merged in a way that leads to voids on the inside of your model. If that’s the case it’s really hard to fix for somebody who doesn’t have experience with pointcloud based 3d modeling.
Please print something that you know is “good”, like the official 3d benchy. I’m almost certain it won’t have the holes that you’re experiencing on your part.
Edit: do you have a link to the moddel? Then I can confirm for you whether the problem is with the mesh or not.
