This is good information. I had a complete failure with flashing Tasmota once, and bricked a $100 device.

I like the project, though. My biggest complaint is that - at least for what I was trying to flash, the Linux support was iffy. I was trying to flash something for HA, and the instructions assumed I had access to the computer running HA (which is a headless device in a closet in the basement - entirely unpractical for doing fiddly pinning while trying to flash) or using a web browser with webUSB - which Firefox on Linux doesn’t. So eventually I found a completely unrelated set of instructions I could run from the CLI from my desktop over a cable connected to said desktop, and while it appeared successful, the device is bricked. I can’t even get it into flash mode anymore.

I don’t think any of this has to do with Tasmota, except that the Linux tooling seems either weak, or make assumes people are running Chrome; and if you’re security conscious enough to be flashing a device to run Tasmota, you’re not running Chrome.

So I’m not doing that again. It’s a hundred bucks and two days of digging around for tooling and instructions I’d like back.

Again, not Tasmota’s fault, but it’s not super accessible.