One painful firmware update later and the z-offset bug that has plagued me since getting the Neptune 4 Pro is finally resolved and first layers are good again just like that. I just had to share the thrilling end result.
You are viewing a single thread.
View all comments 6 points
Don’t forget to swap the springs out too. At least for me my Neptune had trash springs that couldn’t hold tension to save its life. I bought a cheap set on amazon and i stopped banging my head against the wall. Mind you i have the plus, so maybe not an issue for the pro.
5 points
1 point
I printed some locks for the leveling knobs to keep them in place, would new springs do the same thing?
1 point
Doesn’t prevent the screw from turning necessarily. What you need is better tension.
2 points
