Back when I was even less experienced in self-hosting I setup my media/backup server using a RAIDZ1 array and 3 x 8TB disks. It’s been running well for a while and I haven’t had any problems and no disk errors.
But today I read a post about ‘pool design rules’ stating that RAIDZ1 configurations should not have drives over 1TB because the chances of errors occurring during re-silvering are high. I wish I had known this sooner.
What can I do about this? I send ZFS snapshots to 2 single large (18TB) hardrives for cold backups, so I have the capacity to do a migration to a new pool layout. But which layout? The same article I referenced above says to not use RAIDZ2 or RAIDZ3 with any less than 6 drives…I don’t want to buy 3 more drives. Do I buy an additional 8TB drive (for a total of 4 x 8TB) and stripe across two sets of mirrors? Does that make any sense?
Thank you!
If the actual error rate were anywhere near that high, modern enterprise hard drives wouldn’t be usable as a storage medium at all.
A 65% filled array of 10x20TB drives would average at least 1 bit failure on every single scrub (which is full read of all data present in the array), but that doesn’t actually happen with any real degree of regularity.
Then why do you think manufacturers still list these failure rates (to be sure, it is marked as a limit, not an actual rate)? I’m not being sarcastic or facetious, but genuinely curious. Do you know for certain that it doesn’t happen regularly? During a scrub, these are the kinds of errors that are quietly corrected (althouhg the scrub log would list them), as they are during normal operation (also logged).
My theory is that they are being cautious and/or perhaps don’t have any high-confidence data that is more recent.
